Ubiquiti Networks AF-24 Uživatelská příručka Strana 11

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 36
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 10
airFiber
Configuration
The instructions in this section explain how to access the airFiber
Configuration Interface and configure the following settings:
Wireless Mode Configure one airFiber AF-24 as the Master and
the other as the Slave.
Duplex The airFiber AF-24 supports both half-duplex and
full-duplex operation. Half-duplex operation provides more
frequency planning options at the cost of higher latency
and throughput. Full-duplex operation provides the highest
throughput and lowest latency; however, you have fewer
frequency management options.
- Half Duplex (default) The TX and RX Frequencies can be the
same or different to suit local interference.
TX
RX
TX
SlaveMaster
Frequency A
Frequency A
RX
Half-Duplex Diagram
- Full Duplex The TX and RX Frequencies should be different.
TX
RX
TX
RX
SlaveMaster
Frequency A
Frequency B
Full-Duplex Diagram
TX and RX Frequencies The TX Frequency on the Master must
match the RX Frequency on the Slave, and vice versa.
9
airFiber Configuration
Zobrazit stránku 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Komentáře k této Příručce

Žádné komentáře